Front-end Electronics Test for the LHCb Muon Wire Chambers

This document describes the apparatus and procedures implemented to test Multi Wire Proportional Chambers (MWPC) after front-end assembly for the LHCb Muon Detector. Results of measurements of key noise parameters are also described. Given a fully equipped chamber, this system is able to diagnose every channel performing an analysis of front-end output drivers’ response and noise rate versus threshold. Besides, it allows to assess if the noise rate at the experiment threshold region is within appropriate limits. Aiming at an automatic, fast and user-friendly system for mass production tests of MWPC, the project has foreseen as well electronic identification of every chamber and front-end board, and data archiving in such a way to make it available to the Experiment Control System (ECS) while in operation

First results from an aging test of a prototype RPC for the LHCb Muon System

Recent results of an aging test performed at the CERN Gamma Irradiation Facility on a single--gap RPC prototype developed for the LHCb Muon System are presented. The results are based on an accumulated charge of about 0.45 C/cm$^2$, corresponding to about 4 years of LHCb running at the highest background rate. The performance of the chamber has been studied under several photon flux values exploiting a muon beam. A degradation of the rate capability above 1 kHz/cm$^2$ is observed, which can be correlated to a sizeable increase of resistivity of the chamber plates. An increase of the chamber dark current is also observed. The chamber performance is found to fulfill the LHCb operation requirements.Comment: 6 pages, 9 figures, presented at the International Workshop on Aging Phenomena in Gaseous Detectors'', DESY-Hamburg (Germany), October 200

Preliminary results of an aging test of RPC chambers for the LHCb Muon System

The preliminary results of an aging test performed at the CERN Gamma Irradiation Facility on a single--gap RPC prototype developed for the LHCb Muon System are presented. The results are based on an accumulated charge density of 0.42 C/cm^2, corresponding to about 4 years of LHCb running at the highest background rate. We observe a rise in the dark current and noise measured with source off. The current drawn with source on steadily decreased, possibly indicating an increase of resistivity of the chamber plates. The performance of the chamber, studied with a muon beam under several photon flux values, is found to still fulfill the LHCb operation requirements.Comment: 4 pages, 6 figures, presented at RPC2001, VIth Workshop on Resistive Plate Chambers and Related Detectors, November 26-27 2001, Coimbra, Portuga

New results from an extensive aging test on bakelite Resistive Plate Chambers

We present recent results of an extensive aging test, performed at the CERN Gamma Irradiation Facility on two single--gap RPC prototypes, developed for the LHCb Muon System. With a method based on a model describing the behaviour of an RPC under high particle flux conditions, we have periodically measured the electrode resistance R of the two RPC prototypes over three years: we observe a large spontaneous increase of R with time, from the initial value of about 2 MOhm to more than 250 MOhm. A corresponding degradation of the RPC rate capabilities, from more than 3 kHz/cm2 to less than 0.15 kHz/cm2 is also found.Comment: 6 pages, 7 figures, presented at Siena 2002, 8th Topical Seminar on Innovative Particle and Radiation Detectors 21-24 October 2002, Siena, Ital

Performance of the Muon Identification at LHCb

The performance of the muon identification in LHCb is extracted from data using muons and hadrons produced in J/\psi->\mu\mu, \Lambda->p\pi and D^{\star}->\pi D0(K\pi) decays. The muon identification procedure is based on the pattern of hits in the muon chambers. A momentum dependent binary requirement is used to reduce the probability of hadrons to be misidentified as muons to the level of 1%, keeping the muon efficiency in the range of 95-98%. As further refinement, a likelihood is built for the muon and non-muon hypotheses. Adding a requirement on this likelihood that provides a total muon efficiency at the level of 93%, the hadron misidentification rates are below 0.6%.Comment: 17 pages, 10 figure

Measurement of the front-end dead-time of the LHCb muon detector and evaluation of its contribution to the muon detection inefficiency

A method is described which allows to deduce the dead-time of the front-end electronics of the LHCb muon detector from a series of measurements performed at different luminosities at a bunch-crossing rate of 20 MHz. The measured values of the dead-time range from 70 ns to 100 ns. These results allow to estimate the performance of the muon detector at the future bunch-crossing rate of 40 MHz and at higher luminosity

Charged kaon lifetime at KLOE

Preliminary result on the charged kaon lifetime, obtained by the KLOE experiment operating at DA$\Phi$NE, the Frascati $\phi$-factory, is presentedComment: 3 pages, 3 figures, to appear in the proceedings of 42nd Rencontres de Moriond on Electroweak Interactions and Unified Theories, La Thuile, Aosta Valley, Italy, 10-17 Mar 200

Measurement of hadronic cross section and preliminary results on the pion form factor using the radiative return at DAPHNE

In the fixed energy environment of the $e^{+}e^{-}$ collider DA$\Phi$NE, KLOE can measure the cross section of the process $e^{+}e^{-} \to$ hadrons as a function of the hadronic system energy using the radiative return. At energies below 1 GeV, $e^{+}e^{-} \to \rho \to \pi^{+}\pi^{-}$ is the dominating hadronic process. We report here on the status of the analysis for the e^{+}e^{-} \to \ppg channel, which allows to obtain a preliminary measurement of the pion form factor using an integrated luminosity of $\sim73 pb^{-1}$.Comment: Invited talk at the Seventh International Workshop on Tau Lepton Physics (TAU02-WE07), Santa Cruz, Ca, USA, Sept 2002, 9 pages, LaTeX, 9 eps figure

Measurements of the Absolute Branching Ratios for the Dominant KL Decays, the KL Lifetime, and Vus with the KLOE Detector

From a sample of about 10^9 Phi mesons produced at DAFNE, we have selected KL mesons tagged by observing KS->pi+pi- decays. We present results on the major KL branching ratios, including those of the semileptonic decays needed for the determination of Vus. These branching ratio measurements are fully inclusive with respect to final-state radiation. The KL lifetime has also been measured.Comment: Submitted to Phys. Lett.

A direct search for the CP-violating decay Ks->3p^0 with the KLOE detector at DAFNE

We have searched for the decay Ks->3p^0 with the KLOE experiment at DAFNE using data from e^+ e^- collisions at a center of mass energy W= m(phi) for an integrated luminosity L=450 pb^-1. The search has been performed with a pure Ks beam obtained by tagging with Kl interactions in the calorimeter and detecting six photons. We find an upper limit for the branching ratio of 1.2x10^-7 at 90% C.L.Comment: 15 pages, 6 figures. To be submitted to Physics Letter